Skip to content
2
Yes
None
1
1000
Name...
/en/products/charge-controller/mppt-charge-controller/
Thumbnail

Categories:

Sub-Categories:

Charge Controller
XTRA Series

The XTRA-N series can display different display units (XDB1 / XDS1 / XDS2).
The series includes a water-repellent housing (design) with protection class IP32.

With the new XTRA-N series, the reliability of the devices has been significantly improved, so they meet a wide range of application requirements.

MPPT XTRA 12-24V
            BUY NOW
MPPT XTRA 12-48V
            BUY NOW

 

MPPT (Max Power Point Tracking) makes optimal use of the full power of your solar modules.

For all common module technologies, optimal for solar systems with module voltages that are higher than the battery voltage. With these controllers you can also use modules that are actually intended for use in grid-connected systems.

The most efficient working point of the solar modules changes due to various factors, such as module temperature, irradiation, module type etc. This working point is constantly monitored by the internal microcontroller and, if necessary, controlled in such a way that the optimal performance of the solar module is given and your batteries are charged with the respective greatest current .

Properties

  • advanced MPPT technology
  • high efficiency of not less than 98%
  • "ultra-fast" recording speed
  • precise detection of several maximum power points (MPP)
  • multifunctional LCD display
  • manual adjustment of the battery types, load control etc.
  • negative grounding via (-) pole
  • RS485 interface with MODBUS industry standard
  • Fully programmable functions via PC software
  • automatic limitation of charging power and current
  • large MPP operating voltage range
  • compatible with lead-acid and lithium-ion batteries
  • Battery temperature compensation function
  • Real-time energy statistics
  • Overheat reduction function
  • several working modes for loading

Datasheet English

Datasheet German

Manual English

Manual German

Tracer AN Series (50-100A)

The Tracer AN series is based on multi-phase synchronous rectification technology (MSRT) and the advanced MPPT control algorithm. With dual-core processor architecture, the products offer high response speed, high reliability and high standards.

The advanced MPPT algorithm reduces the number of MPP lost (points of maximum performance) and the time lost for correction. Due to the increased tracking efficiency and speed, the MPP is set very quickly in order to extract the highest possible performance from the PV modules at all times.

The limiting function of charging power and current, as well as the automatic power reduction protect the system if the PV power is too high or at elevated temperatures.

The adaptable 3-stage charging curve, based on a digital control loop, enables a maximum battery life and an increase in system performance. A hybrid energy system can be easily set up using the load relay and the grid / generator control relay. Comprehensive electronic protection against overcharge, deep discharge, PV reverse polarity etc. ensures a safe and stable solar system.

The isolated RS-485 interface with standard mode protocol and 5V power supply makes system expansion easy. It supports up to 8 charge controllers in parallel operation. This results in a very wide range of uses, from caravans to single-family homes and large systems.

Datasheet English

Datasheet German

Manual English

Manual German

BUY NOW

UPower Series

Inverter / charge controller UPower series from EPSolar for PV / solar applications. Suitable for solar, car, boat, camping, outdoor, caravan, motorhome etc. Ideal for use in remote areas with many hours of sunshine and with a lack of reliable suppliers.

The function of the integrated MPPT charge controller ensures fully digital and efficient energy storage and use. The inverter with integrated charge controller of the UPower series converts 12 / 48V direct current into 220 / 230V 50 / 60Hz alternating current with pure sine wave. The manual adjustment of the utility and PV electricity charges enables the ideal ratio of your energy use. This makes the UPower particularly convincing in remote environments with its reliability and responsiveness.

Characteristics

  • Charge controller and inverter in one device
  • High stability in the output voltage
  • Selection function for the ratio of utility and solar power
  • MPPT technology for determining the maximum credit point
  • Numerous protective functions: over / under voltage of the battery, over / under voltage at inputs and outputs, protection against reverse polarity and short circuits
  • Charging power limits
  • Compensation function for temperature changes
  • Protection against internal overheating with intelligent ventilation
  • Sophisticated SPWM technology for the pure output of sine waves
  • low distortion factor (= THD = 3%)
  • 4.2 "display for showing the system status and real-time data
  • Easy adjustment of the working parameters with 4 buttons
  • Optional: Wi-Fi module for wireless monitoring and control
  • Control using PC software or APP

Technical specifications

  • Nominal battery voltage: 12V or 48V
  • Continuous power: 800W / 4000W
  • Maximum power: 2000W / 10000W (short-term peak)

Datasheet English

Datasheet German

Manual English

Manual German

BUY NOW

DuoRacer Series(10-30A)

Charge controller EPSolar MPPT DuoRacer 10-30A

Highly efficient, compact and reliable charge controller to use the full power of your solar modules

The MPPT charge controller DuoRacer from EPSolar was specially designed to charge two batteries in a solar system at the same time. Several battery types (Sealed, Gel, Flooded, LiFePO4 and Li-NiCoMn) are supported.

  • MPPT Charge Controller 10A-30A
  • 12-24V system voltage
  • MPP voltage range up to 72V
  • Negative grounding

Charge controller EPSolar MPPT DuoRacer 10-30A

The MPPT solar charge controller Duo Racer from EPSolar charges two batteries (BATT1 and BATT2) at the same time and is therefore ideally suited for traveling in RV, caravan or car. With the AES interface, the DuoRacer is able to supply excess PV energy to consumers such as a refrigerator.

BATT1 = Battery storage to supply consumers in an island system, household (supports Sealed, Gel, Flooded, LiFePO4, Li-NiCoMn)
BATT2 = Battery storage for vehicles, boats (supports only lead acid batteries)

Features

  • MPPT technology with efficiency =99.5%.
  • Well-developed MPPT control algorithm to minimize MPP loss rate
  • automatic limitation of charging power and charging current
  • LCD display - display and setting of parameters
  • RS485 port, Modbus protocol
  • Compatible with LiFePo4 and Li-NiCoMn batteries
  • Automatic energy saving mode when charging power is too low
  • Wide MPP operating voltage range
  • Numerous protection mechanisms (deep discharge, overcharge, overvoltage protection)
  • AES port for max. utilization of the PV surplus

Optional

The monitoring and evaluation of the data can be realised by using the PC software. The controller must either be connected directly to the PC via RS485 cable or via WLAN/Bluetooth with the e-box-WiFi / e-box-BLE.

A converter is required to connect consumers with 12V via the AES port.

Datasheet English

Datasheet German

Manual English

Manual English

Tracer BN Series (10-40A)

The Tracer BN series is EPSOLAR's second generation of MPPT control units. Compared to the Tracer series there is an improved communication ability. The die-cast aluminum design also ensures excellent heat dissipation.

Compared to conventional PWM controllers, the MPPT technology increases the charging efficiency by up to 30%.

Properties

  • MPPT (Max Power Point Tracking)
  • Automatic system voltage detection 12/24 V
  • Solar input module open circuit voltage from 5V to 150V open circuit voltage
  • Battery deep discharge protection, overcharge protection, overvoltage protection
  • RS485 / interface, Modbus protocol
  • Monitoring via PC software or MT50 display
  • Temperature-dependent charging parameter correction
  • Fanless convection cooling up to 50 ° C
  • Timer function up to 1-15 hours option for night lighting
  • Automatic day / night detection
  • Load output with switch-off option
  • 4 battery types adjustable (open acid, AGM, gel, user)
  • suitable for lithium batteries

Technical specifications

  • Battery nominal voltage 12/24 DC
  • Module open circuit voltage up to 150V DC
  • Max. Module power 120-480W (12V) / 240-960W (24V)
  • Max. Charging current 10-40 A
  • Type. Own power consumption <50 mA
  • Temperature range - 25 ° C to + 60 ° C
  • Degree of protection IP20
  • Dimensions 302.5 x 182.7 x 63.5 mm
  • Connection terminals 25 mm²

Features

The controller can be monitored and set using the MT50 display or adapter cable and software. The controller can be monitored using the PC software.
4 types of batteries can be set. In the User battery type, the charging voltages are freely selectable and programmable via the software. (Lithium batteries)
A switchable load output gives the user the option of switching on or off all consumers that are connected to the solar charge controller at the push of a button on the controller or via software settings on the PC.
2 timers can control night lighting as soon as the controller detects "night" through the solar module.
Yield measurement of all system parameters and monitoring possible via PC software.
The controller can be set and monitored with the optionally available MT50 display.

Datasheet English

Manual English

Manual German

BUY 10A NOW

BUY 20A NOW

BUY 30A NOW

BUY 40A NOW

iTracer Series

The charge controllers of the iTracer series are industrial goods with an extended Maximum Power Point Tracking (MPPT) algorithm. You can supply the maximum available power for charging batteries.

Properties

  • MPPT (Max Power Point Tracking)
  • Maximum charging current 60 amps
  • Automatic system voltage detection 12/24/36 / 48V
  • Solar input module open circuit voltage from 5V to 145V open circuit voltage
  • Battery deep discharge protection, overcharge protection, overvoltage protection
  • RS485 / Can-bus interfaces available
  • Monitoring via PC software
  • Temperature-dependent charging parameter correction
  • Fanless convection cooling up to 50 ° C
  • Timer function up to 1-15 hours option for night lighting
  • Automatic day / night detection
  • Load output with switch-off option
  • 4 battery types adjustable (open acid, AGM, gel, user)

Technical specifications

  • Battery nominal voltage 12/24/36/48 DC
  • Module open circuit voltage up to 145V DC
  • Max. Module power 720W (12V) / 1440W (24V) / 2160W (36V) / 2880W (48V)
  • Max. Charging current 60 A
  • Type. Own power consumption <1.5 W
  • Temperature range - 25 ° C to + 60 ° C
  • Degree of protection IP20
  • Dimensions in mm 440 x 231 x 110
  • Weight 5.9 kg
  • Connection terminals 35 mm²

Features

The controller can be monitored and set using the software supplied. The controller can be monitored using the PC software.
4 types of batteries can be set. In the user battery type, the voltages are freely selectable and programmable via the software. (Lithium batteries)
A switchable load output gives the user the option of switching on or off all consumers that are connected to the solar charge controller by pressing a button on the controller or via software settings on the PC.
2 timers can control night lighting as soon as the controller detects "night" through the solar module.
Yield measurement of all system parameters and monitoring via PC software possible.

Datasheet English

Manual English

Manual German

BUY NOW

Charge Controller
XTRA Series
The XTRA-N series can display different display units (XDB1 / XDS1 / XDS2). The series includes a water-repellent housing (design) with protection class IP32. With the new XTRA-N series, the reliability of the devices has be... Read More
Tracer AN Series (50-100A)
The Tracer AN series is based on multi-phase synchronous rectification technology (MSRT) and the advanced MPPT control algorithm. With dual-core processor architecture, the products offer high response speed, high reliability and high st... Read More
UPower Series
Inverter / charge controller UPower series from EPSolar for PV / solar applications. Suitable for solar, car, boat, camping, outdoor, caravan, motorhome etc. Ideal for use in remote areas with many hours of sunshine and with a lack of re... Read More
DuoRacer Series(10-30A)
Charge controller EPSolar MPPT DuoRacer 10-30A Highly efficient, compact and reliable charge controller to use the full power of your solar modules The MPPT charge controller DuoRacer from EPSolar was speci... Read More
Tracer BN Series (10-40A)
The Tracer BN series is EPSOLAR's second generation of MPPT control units. Compared to the Tracer series there is an improved communication ability. The die-cast aluminum design also ensures excellent heat dissipation. Compared to... Read More
iTracer Series
The charge controllers of the iTracer series are industrial goods with an extended Maximum Power Point Tracking (MPPT) algorithm. You can supply the maximum available power for charging batteries. Properties ... Read More